Questions about wall and ceiling

In principle, ClickBoard and our panels can be used in all living spaces, for walls, ceilings, roof extensions and also for lightweight construction walls. They can be used in wet rooms such as domestic bathrooms if they are not in the direct splashing water area.

Like floor coverings, our decor panels also need a sufficiently wide expansion joint on all sides so that the wood-based panels can adjust their moisture content without tension and bulging. The end mouldings are used to cover these movement joints. In the case of external corners, the end mouldings also conceal the panel edges.

"We make two recommendations for the start of the installation work: 1. If possible, start at the side of the window and work towards the room. 2. In addition, the installation of decorative panels on a pitched roof must be carried out from top to bottom so that no moisture can get into the groove (risk of swelling)."

Yes, our panels offer good light resistance to fading caused by sunlight. The light resistance is tested according to DIN EN ISO 4892-2 using so-called xenon arc lamps.

If you wish to paint our panels due to renovation work, this is possible, but you should use a suitable decorator's tape for the masking work. Please note that conventional adhesive tape can damage the decor. In the event of any decorating, please also note that in the case of panels with a mini bevel, the joint area must not be completely filled.

The surfaces of decor and ClickBoard panels are very easy to clean. The surfaces are wiped with a damp, well wrung out cloth and a commercial, non-layer-forming cleaner. Under no circumstances should a steam cleaner be used.